- 14 -
Step 2.
Set Jumpers
This mainboard is jumperless! The default jumper settings have been set for
the common usage standard of this mainboard. Therefore, you do not need
to reset the jumpers unless you require special adjustments as any of the
following cases:
1. Over-clock your CPU
2. Disabled the onboard audio before installing an add-on sound card
3. Clear CMOS
4. Clear system password
5. Clear PS/2 Keyboard Power on password
For first-time DIY system builders, we recommend that you do not change the
default jumper settings if you are not totally familiar with the mainboard
configuration procedures. The factory-set default settings are tuned for opti-
mum system performance. For the advanced users who wish to customize
their system, section
will provide detailed information on
how to configure your mainboard manually.
Step 3
Install SDRAM System Memory
To install memory, insert SDRAM memory module(s) in any one or two or
three DIMM banks. Note that SDRAM modules are directional and will not
go in the DIMM slots if they are not properly oriented. After the module is
fully inserted into the DIMM slot, lift the clips of both sides of the DIMM bank
to lock the module in place.
