21
IGA1680 PCI VGA
Step 7.
Follow the instruction to proceed installation. When ‘Display Driver Install’ dialog box
appears, select ‘Primary Display’ and then click on the
O.K.
button.
Step 8.
When ‘Primary Display Adapter Type’ dialog box appears, select “InteGraphics Systems,
Inc. IGA1680” and then click on the
O.K.
button.
Step 9.
When ‘Select Display Resolution’ dialog box appears, select the resolution which best fits
your needs, and then click on the
O.K.
button.
Step10.
When ‘Source Directory’ dialog box appears, click the button “Change” to set your source
directory to c:\os2_drv before you push the button “Install...” (This is a very important
procedure to follow for installing from a directory instead of a diskette).
Step11.
After the installation completed, perform a shutdown and restart the system so that the
changes can take effects.
Note:
In the case that the display loses sync after the system restarts, f ollow the procedures
below:
1)
Reboot the system with a bootable floppy (DOS).
2)
Run InteGraphics provided utility - SetFreq.Exe. Select a low refresh rate for
your monitor. If you have an interlaced monitor and you are going to use it in
1024x768 resolution, you must select 1024x768 interlaced mode. Then,
choose not to save the selection into Autoexec.bat file.
3)
Change to directory C:\OS2.
4)
Type
SVGA ON DOS
and <Enter>, which will generate SVGADATA.DOS
file under the directory \OS2.
5)
Type
Copy SVGADATA.DOS SVGADATA.PMI
and <Enter>.
