- 37 -
3.3 System Memory Configuration
The FB95 mainboard has two 240-pin DIMM slots that allow you to install
from 128MB up to GB of system memory. Each 240-pin DIMM (Dual In-line
Memory Module) Slot can accommodate 128MB, 256MB, 512MB, and
1GB.
Install Memory:
Install memory in any or all of the banks. The combination shown as follows.
Note: 1. Maximum installed memory is 2GB.
2. Double-side X16 DDRII DRAM chips are not supported.
3. Registered DIMM are not supported.
4. Only unbuffered without ECC DIMM are supported.
Note : You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically.
You can check the total system memory value in the BIOS Standard
CMOS Setup menu.
Upgrade Memory:
You can easily upgrade the system memory by inserting additional DDRII DRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new system
memory value will automatically be computed and displayed in the field " Stan-
dard CMOS Setup" of BIOS setup program.
T O T A L 2 D I M M i n S i n g l e o r D u a l C h a n n e l M o d e
u p t o 4 G B a n d 2 G B p e r DIM M
D e n s ity
1 2 8 M b it
2 5 6 M b it
5 1 2 M b it
1 0 2 4 M b it
D e v i c e
W idth
X8
X16
X8
X16
X8
X16
X8
X16
Single Side
128
MB
128
MB
256
MB
256
MB
512MB
512
MB
1024
MB
1024
MB
D o u b le
S i d e
256
MB
256
MB
512
MB
512
MB
1024
MB
N/A
2048
MB
N/A
