- 58 -
Power Management
This item acts like a master switch for the power-saving modes and hard
disk timeouts. If this item is set to Max Saving, power-saving modes
occur after a short timeout. If it is set to Min Saving, power-saving
modes occur after a longer timeout. If it is set to User Define, you can
insert your own timeouts for the power-saving modes.
Ø
The choice: Min Saving, Max Saving, or User Define.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen
The item only writes blanks to the video buffer.
DPMS
Initial display power management signaling.
Ø
The choice: V/H SYNC+Blank, Blank Screen, or DPMS.
Video Off In Suspend
This item determines the manner in which the monitor is blanked.
Ø
The choice: Yes or No.
Suspend Type
This item allows you to select the Suspend Type.
Ø
The choice: Stop Grant or PwrOn Suspend.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø
The choice: 3, 4, 5, 7, 9, 10, 11, or NA.
Suspend Mode
When this item is not disabled and after the setup time of system inactiv-
ity, all devices except the CPU will be shut off.
Ø
The choice: Disabled, 1 Min, 2 Min, 4 Min, 8 Min, 12 Min, 20 Min,
30 Min, 40 Min, or 1 Hour.
HDD Power Down
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disabled.
Ø
The choice: Disabled or 1 Min~15 Min.
Soft-Off by PWR-BTTN
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay
