![background image](http://html.mh-extra.com/html/shure/microflex-mxwani8/microflex-mxwani8_quick-setup-manual_1261026009.webp)
•
Dispose of battery packs properly. Check with local vendor for proper
disposal of used battery packs.
•
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like
WARNING:
Danger of explosion if incorrect battery replaced. Operate only
with AA batteries.
Note:
Use only with the included power supply or a Shure-approved equiva-
lent.
1. 經審驗合格之射頻電信終端設備,非經許可,公司、商號或使用者均不
得擅自變更頻率、加大功率或變更原設計之特性及功能。
2. 射頻電信終端設備之使用不得影響飛航安全及干擾合法通信;經發現有
干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。所謂合法
通信,係指依電信法規定作業之無線電信。
3. 輸入、製造射頻電信終端設備之公司、商號或其使用者違反本辦法規定,
擅自使用或變更無線電頻率、電功率者,除依電信法規定處罰外,國家
通訊傳播委員會並得撤銷其審驗合格證明。
4. 減少電磁波影響,請妥適使用
MXW1
These transmitters have been tested and found to comply with international
radiation exposure limits set forth for an uncontrolled environment. This
equipment is in direct contact with the body of the user under normal operating
conditions. These transmitters must not be co-located or operating in con-
junction with any other antenna or transmitter.
MXW2, MXW6, MXW8, MXWAPT2, MXWAPT4, MXWAPT8
These mobile transmitters are intended for use at distances greater than 20
centimeters from the human body. These mobile transmitters are exempt
from the testing requirements of international radiation exposure standards
due to their proximity to the body of the user in their intended use case and
their low power output. These mobile transmitters shall be placed or installed
at least 20 cm from any person and must not be co-located or operating in
conjunction with any other antenna or transmitter.
Important Product Information
The equipment is intended to be used in professional audio applications.
EMC conformance testing is based on the use of supplied and recommended
cable types. The use of other cable types may degrade EMC performance.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate this equipment.
Please follow your regional recycling scheme for batteries, packaging, and
electronic waste.
Note:
This device is not intended to be connected directly to a public internet
network.
Information to the user
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Certifications
This device complies with FCC Part 15.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation of this device is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any inter-
ference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Japanese Radio Law and Japanese Telecommunications Business Law
Compliance. This device is granted pursuant to the Japanese Radio Law (電
波法) and the Japanese Telecommunications Business Law (電気通信事業
法). This device should not be modified (otherwise the granted designation
number will become invalid).
Conforms to electrical safety requirements based on IEC 60065.
Meets essential requirements of the following European Directives:
•
WEEE Directive 2002/96/EC, as amended by 2008/34/EC
•
RoHS Directive 2011/65/EU
Note:
Please follow your regional recycling scheme for batteries and
electronic waste
Hereby, Shure Incorporated declares that the radio equipment is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address: http://www.shure.com/eu-
rope/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: [email protected]
MXWNCS2, MXWNCS4, MXWNCS8
Authorized under the FCC verification provision per Part 15b.
Industry Canada ICES-003 Compliance Label:
CAN ICES-3 (B)/NMB-3(B)
Note:
See the label located on the bottom side of the charger enclosure for
the FCC marking, the CE marking, the RCM marking, and the electrical rat-
ings.
MXW1, MXW2, MXW6, MXW8, MXWAPT2, MXWAPT4,
MXWAPT8
Certified under FCC Part 15.
FCC:
DD4MXW1, DD4MXW2, DD4MXW6, DD4MXW8, DD4MXWAPT4,
DD4MXWAPT8.
Meets applicable requirements of RSS-213.
Shure Incorporated
MXW
Quick Setup
9/10
2017/10/06