If no selected music project and enter this interface through main interface, it shows “no
project”.
The "Rescan Universe" button only works if there are project files. When "Pyro Arm" is turned
on, click rescan universe to display the status of the slave and igniter used in the corresponding
file in the table (the Slave and igniter that not used in the file will not be displayed even if they
are in an abnormal state).
Region 2:
check the detailed status of Pyro Slave.
Bat:
80% shows the state of charge.
Two small circles in the middle shows the high frequency and low frequency wireless signal
respectively (Green – signal good, White – no signal).
Line between each group of black and red dot shows igniter status:
Green:
used in the cue, connected.
Red:
used in the cue, not connected.
Black:
not used in the cue, but connected.
White:
not used in the cue, not connected.
"Up" and "Down”:
switch from slaves.
Address range for igniter 00~FF.
Check Slave interface
Note:
Keep “customer ID” of FXcommander
TM
and Slave in accordance with the signal channel. If
there is no signal, please set in “settings” interface. Check the Slave igniter status need to
switch ON “Pyro Arm”.
