15
Ordercode: 61133
WTF-FZ1500 1500W DMX Fazer
1 Channel (Sync)
Channel 1 – Faze effect
0–5
Faze effect OFF, fan speed: 20 %
6–255
Faze effect ON: 1–100 %, fan speed: 21–100 %
2 Channels
Channel 1 – Faze effect
0–5
Faze effect OFF
6–255
Faze effect ON: 1–100 %
Channel 2 – Fan speed
0–5
Not functional
6–255
Fan speed: 20–100 %
Maintenance
The WTF-FZ1500 requires almost no maintenance. However, you should keep the unit clean. Disconnect
the mains power supply and then wipe the cover with a damp cloth. Do not use alcohol or solvents. Do
not immerse in liquid.
Keep connections clean. Disconnect electric power, and then wipe the connections with a damp cloth.
Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Remove dust from the air vents with an air compressor, vacuum or a soft brush (excessive dust, liquid and
dirt built up will degrade performance and may cause overheating). Run the machine on monthly basis
in order to achieve best performance and output condition.
Do not allow the fog liquid to become contaminated. Always close the fog liquid tank immediately after
adding the fog liquid to the tank.
Performance
Note:
●
Fog machines develop condensation around the output nozzle. Because this may result in moisture
accumulation on the surface below the output nozzle, consider this condensation when installing
your machine. Fog machines may occasionally sputter small amounts of fog, during operation
and/or after being turned off.
●
WTF-FZ1500 faze machine has a heating cycle after bursts of fog so the machine stops fogging for a
short period in order to heat up. During this time no fog can be produced.
●
Only use the recommended fog liquids.
Cleaning
Before storing the WTF, it needs to be cleaned.
01)
Whenever the display shows READY TO FAZE, press and hold down the ENTER button for 4 seconds.
02)
The display will show CLEANING. The process will take 180 seconds.
03)
The display will show CLEANING FINISH.
04)
Unplug the device.
Replacing the Fuse
You do not have to replace the fuse on this device as the fuse is automatic.
01)
In case of a power surge, short-circuit or inappropriate power supply, press the breaker button (07)
and the device will function normally.
02)
Try to determine the cause of the problem, so that the situation does not happen in the future.
Summary of Contents for WTF-F1000
Page 20: ...2020 Showtec...
