8
One Inferno
1.
Fasten the Inferno onto firm trussing. Leave at least 1 meter on all sides for air circulation.
2.
Plug one end of the electric mains power cord into the IEC socket on the unit
.
Then plug the other end of the cord into a proper electric power supply socket.
3.
If the display shows , you can change the speed of the gobo-wheel by using the
Up/Down buttons.
Multiple Inferno’s
1.
Fasten the effect light onto firm trussing
. Leave at least 1 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the
Inferno’s
and other devices.
The pins:
1.
Earth
2.
Signal -
3.
Signal +
3.
Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other
end of the mains power cord into proper electric power supply sockets, starting with the first unit. Do
not supply power before the whole system is set up and connected properly.
Multiple Inferno’s Set Up
DMX-Set up
Fig. 4
Note : Link cables before connecting electric power
DMX Protocol
The Inferno can be operated with a controller in
control mode
or without the controller in
stand-alone
mode.
DMX Channels
Channel 1 - Dimmer / Shutter
0
Stop
1-127
Forwards continuous rotating from slow to fast
128-255
Backwards continuous rotating from fast to slow
Summary of Contents for Starzone Inferno DMX
Page 1: ...Starzone Inferno DMX ORDERCODE 31323...
Page 14: ......
