27
Ordercode: 40428
Star Dream 6x4m 192 LED White
Channel 11 – LED group 7
CH1 must be open; CH3 must be set between 0–49
0–255
Gradual adjustment White, from dark to brightest
Channel 12 – LED group 8
CH1 must be open; CH3 must be set between 0–49
0–255
Gradual adjustment White, from dark to brightest
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02)
There may not be any deformations on housings, fixations and installation spots.
03)
Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04)
The electric power supply cables must not show any damages or material fatigue.
The Star Dream 6x4m 192 LED White requires almost no maintenance. However, you should keep the
controller clean. Otherwise, the fixture’s light output will be significantly reduced. Disconnect the mains
power supply, and then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe LEDs clean
with glass cleaner and a soft cloth. Do not use alcohol or solvents.
Please clean internal components once a year with a light brush and vacuum cleaner.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the LEDs, the internal fuse.
01)
Power supply. Check if the controller is plugged into an appropriate power supply.
02)
The LEDs. Return the Star Dream to your Showtec dealer.
03)
The internal fuse. Return the Star Dream to your Showtec dealer.
04)
If all of the above appears to be O.K., plug the unit in again.
05)
If you are unable to determine the cause of the problem, do not open the Star Dream, as this may
damage the unit and the warranty will become void.
06)
Return the device to your Showtec dealer.
No Response to DMX
Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card malfunction.
01)
Check the DMX setting. Make sure that DMX addresses are correct.
02)
Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03)
Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.
