14
Ordercode: 40428
Star Dream 6x4m 192 LED White
The Star Dream can be operated with a controller in control mode or without the controller in
stand-alone mode.
Control Panel
A) LCD display
B) UP button
C) DOWN button
D) ENTER button
E) MODE button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the Star Dream will respond to the controller.
Please note, when you use the controller, the unit has 12 channels.
When using multiple Star Dreams, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Star Dream should be 1(001); the DMX address of the second Star
Dream should be 1+12=13 (013); the DMX address of the third Star Dream should be 13+12=25 (025), etc.
Please, be sure that you do not have any overlapping channels in order to control each Star Dream
correctly. If two or more Star Dreams are addressed similarly, they will work similarly.
Controlling:
After having addressed all Star Dream fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Star Dream will automatically detect whether DMX 512 data is received or
not.
If there is no data received at the DMX-input, the “LED“ on the control panel will not flash.
If not, the problem may be:
●
The XLR cable from the controller is not connected with the input of the Star Dream.
●
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 10 seconds
When no button is pressed for 10 seconds, the display will turn off.
To light up the display, you have to press the MODE button.
Once you have pressed the button, the display will light up.
