SHOWTEC Shark Beam FX one, Manual

Page: 11 / 32

10
Ordercode: 45023
Shark Spot One
Control Modes
There are 5 modes:
• Auto show
• Built-in programs
• Sound-controlled
• Master/Slave
• DMX-512 (8CH, 14CH)
One Shark (Auto show, Built-in programs and Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Shark is not connected with a DMX cable, it functions as a stand-alone device.
04) Turn on the music. If the device is set to sound-control, then the Shark will react to the beat of the
music.
05) Please see pages 15-16 for more information about the Auto show, Built-in programs and Sound-
controlled mode.
Multiple Sharks (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Shark.
The pins: 01) Earth
02) Signal -
03) Signal +
03) Link the units as shown in fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units. You
can use the same functions on the master device as described on pages 15-16 (Auto show, Built-in
programs or Sound-controlled mode). This means that you can set your desired operation mode on
the master device and all slave devices will react the same as the master device.
Multiple Sharks (Master/Slave control)
Fig. 04