7
Installation
Installing the Lamp
The Showtec Quatro uses 4x R7-S (ordercode 82282) bulb as manufactured by all popular manufacturers.
Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage
! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
1.
Loosen the 6 screws (Fig. 4.1) of the housing. Gently remove the metal housing.
1.
Loosen the 2 screws (Fig. 4.2) of the glass lamp cover. Gently remove the cover.
3.
Read lamp instructions. Do not touch the lamp bulb glass.
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free
towel and rubbing alcohol.).
4.
Insert the lamp in the lamp socket. First insert the left side (Fig. 4.3) and then the right side (Fig. 4.4).
5.
Put the lamp cover back and fasten the screws snugly. Then put the metal housing back and fasten
The screws snugly.
1
2
3
4
Fig. 4
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Summary of Contents for QUATRO 50462
Page 1: ...Quatro ORDERCODE 50462...
Page 19: ......
