8
Ordercode: 41304
Pixel Bar 12 MKII
One Pixel Bar (Built-in programs, Auto Run)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
When the Pixel Bar is not connected by a DMX-cable, it functions as a stand-alone device.
04)
If device is set to
or
, then the fixture will play one of its built-in programs or show its
auto run mode. Please see page 15 for more information about the built-in programs or auto run
mode.
Multiple
Pixel Bars
(
Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
Use a 3-p XLR cable to connect the Pixel Bars and other devices.
The pins:
1.
Earth
2.
Signal (-)
3.
Signal (+)
05)
Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third units. You can use the
same functions on the master device as described on pages 14-15 (Static control, Built-in Programs,
Auto run). This means you can set your desired operation mode on the master device and all slave
devices will react the same as the master device.
Multiple Pixel Bars
(
Master/Slave control)
Fig. 03
