11
Maintenance
The Showtec
LED Tube Basic Controller
requires almost no maintenance. However, you should keep the unit
clean. Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections with a
damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric
power.
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the fuse
burns out, the product will not function whatsoever. If this happens,
follow the directions below to do so.
1.
Unplug the unit from electric power source.
2.
Insert a screwdriver into the slot in the fuse cover. Turn the screwdriver to the left, at the same time gently
push a bit (Turn and Push). The fuse will come out.
3.
Remove the broken fuse. If brown or unclear, it is burned out.
4.
Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover.
Be sure to use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
Showtec LED Tube Controller
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following steps.
1.
If the device does not operate properly, unplug the device.
2.
Check power from the wall, all cables, the fuse, etc.
3.
If all of the above appears to be O.K., plug the unit in again.
4.
If nothing happens after 30 seconds, unplug the device.
5.
Return the device to your Showtec dealer.
Summary of Contents for LED Music Tube Controller
Page 1: ...LED Tube Basic Square ORDERCODE 41014...
Page 15: ...2007 Showtec...
