Ordercode: 43715
Helios 200 COB Q4
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 6 modes:
•
Manual Mode (Static Color)
•
Auto Mode
•
Built-in programs
•
Sound-controlled
•
Master/Slave
•
DMX-512 (4CH, 6CH, 7CH, 8CH, 11CH)
One Helios (Manual Mode, Auto Mode, Built-in programs and Sound-controlled)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Plug the end of the electric mains power cord into a proper electric power supply socket.
03)
When the Helios is not connected with a DMX cable, it functions as a stand-alone device.
04)
Turn on the music. If the device is set to sound-control, then the Helios will react to the beat of the
music.
05)
Please see page 16-18 for more information about the Built-in programs, Auto mode, Sound-
controlled and Manual mode.
Multiple Helioses (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Use a 3-pin/5-pin XLR cable to connect the Helios.
The pins:
01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 16-18 (Built-in
programs, Auto mode, Manual mode or Sound-controlled mode). This means that you can set your
desired operation mode on the master device and all slave devices will react the same as the
master device.
Multiple Helioses (Master/Slave control)
Fig. 03
11
