SHOWTEC Expression 5000, Product Manual

Page: 10 / 31

8
Backside
Fig. 2
3 4 5 6 7
3) DMX signal connector (IN) 3-pin
4) DMX signal connector (OUT) 3-pin
5) IEC power con Fuse T3,15A 250V
6) ON/OFF
7) Earth
Installation
Remove all packing materials from the Expression 5000 . Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.