SHOWTEC Dynamic LED V4, Manual

Page: 9 / 24

8
Ordercode: 43056
Dynamic LED
Backside
Fig. 02
03)
3-pin DMX signal connector IN
04) 3-pin DMX signal connector OUT
05) Ground/earth connection
06) IEC Power connector IN + Fuse T1L/250V
07) LED d menu buttons
08) Safety eye
Installation
Remove all packing materials from the Dynamic LED. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be sound-controlled as it is equipped
with a built-in microphone.