SHOWTEC Dreamwave V1, Manual

Page: 18 / 32

17
Ordercode: 43166
Dreamwave
7. Sensitivity Mode
With this menu you can set the Sensitivity control.
01)
Press the MENU button and then the Up / Down buttons, until the display shows .
02) Press the ENTER button to open this menu.
03) You can choose 100 different Audio Sensitivity levels .
04) Press the SETUP button to confirm your choice.
8. Blackout/DMX Fail Mode
With this menu you can set the device’s behavior in case of a DMX signal error.
01)
Press the MENU button and then the Up / Down buttons, until the display shows .
02) Press the ENTER button to open this menu.
03) Press the UP/DOWN buttons to select one of the 3 options:
●
If the DMX signal is lost, the device will not blackout, it will automatically start its selected
program .
● : If the DMX signal is lost, the device will not blackout, it will use its last properly received
DMX signal, ensuring undisrupted performance.
● OFF: If the DMX signal is lost, the device will black out the light output. Do not use this
option when the device is used as a stand-alone device (i.e. without a DMX signal and without
an XLR cable). The moving head will remain in a blackout state, no matter what setting you
have set in one of the stand-alone modes.
9. Backlight
With this menu you can set the backlight of the display.
01) Press the MENU button until the display shows .
02) Press the ENTER button to open this menu.
03) If you choose “Off”, the display will blackout after 15 seconds.
04) If you choose “On”, the display will always light up, even if there is no operation at the device.
05) Press the MODE button to go back to the previous step.
10. Display settings
01)
Press the MENU button and then the Up / Down buttons, until the display shows .
02) Press the SETUP button to enter the menu.
03) Press the UP and DOWN buttons to toggle between:
Normal Display
Display Invert
04) Press the SETUP button to confirm your choice.