9
Ordercode: 42653
Club Par Dizzy 3/8
Backside
Fig. 02
05)
LED d control buttons
06)
IEC power connector OUT
07)
Mounting bracket with inclined screw
08)
IEC power connector IN
09)
Fuse T1L/250V
10)
Cooling fan
11)
Built-in microphone
12)
Sound sensitivity control
13)
Safety eye
14)
3-pin DMX signal connector IN
15)
3-pin DMX signal connector OUT
Installation
Remove all packing materials from the Club Par Dizzy. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
