9
Ordercode: 50396
Single DP-1
DMX Channels
1 channel
Channel 1 – Dimmer intensity
0-255
Gradual adjustment, from dark to brightest
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02)
There may not be any deformations on housings, fixations and installation spots.
03)
The electric power supply cables must not show any damages or material fatigue.
The Single DP-1 requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Keep connections clean. Disconnect electric power, and then wipe the DMX connections with a
damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric
power.
Replacing the Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens,
follow the directions below.
01)
Unplug the unit from electric power source
.
02)
Insert a flat-headed screwdriver into a slot in the fuse cover. Turn the screwdriver to the left, at the
same time gently push a bit (Turn and Push). The fuse will come out.
03)
Remove the used fuse. If brown or unclear, it is burned out
.
04)
Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse holder. Be sure
to
use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out the
following steps. Suspect two potential problem areas as: the power supply and the fuse.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02)
The fuse. Replace the fuse. See page 9 for replacing the fuse.
03)
If both appear to be O.K., plug the unit in again.
04)
If you are unable to determine the cause of the problem, do not open the Single DP-1, as this may
damage the unit and the warranty will become void.
05)
Return the device to your Showtec dealer.
Summary of Contents for 50396
Page 12: ... 2019 Showtec ...
