
20
Pinspot Bar 4 RGBW
Product code: 30295
6.
Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for professional use as a T-bar. It is suitable only for indoor installation. This device is
not suitable for households and for general lighting.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Control Modes
The Pinspot Bar 4 RGBW supports the following control modes:
●
Stand-alone:
Manual, Auto, Program
●
Master/Slave:
Manual, Auto, Program
●
DMX-512, RDM
4, 5, 6, 8, 10, 16, 19 channels
For more information about how to connect the devices, refer to 5. Setup on pages 17–19.
To operate the device manually as a stand-alone device or in a master/slave setup:
●
Adjust the colors in Manual menu. See 6.6.2. Manual Mode on page 25 for more information.
To run the built-in programs without a DMX controller:
Select one of the 23 built-in programs in Program menu. See 6.6.4. Program on page 26 for more
information. Adjust the program speed and strobe frequency.
Run all built-in programs in a sequence in Auto menu. See 6.6.3. Auto on page 26 for more
information.
To run the preset colors without a DMX controller:
Select one of the 33 preset colors in Program menu. See 6.6.4.1. Program 01 on page 27 for more
information.
To operate the device with a DMX controller:
01)
Set the DMX starting address of the device in Address menu. See 5.3.5. DMX Addressing on page 19
and 6.6.1.1. Address on page 25.
02)
Select the DMX channel mode. See 6.6.1.2. Channels on page 25 for more information. See 6.7. DMX
Channels on pages 32–34 for complete overview of all DMX channels.