
15
Pinspot Bar 4 RGBW
Product code: 30295
Angle Adjustment
You can adjust the angle of the device with the adjustment screws (15).
01)
Turn the adjustment screws (15) counterclockwise to release them.
02)
Tilt the device to the desired angle (see Fig. 08).
03)
Turn the adjustment screws (15) clockwise to tighten them. Make sure that the device cannot move
freely after the adjustment screws (15) are tightened.
Fig. 08
Beamshaper Installation
You can use the optional beamshaper in order to change the beam angle of the device.
Place the beamshaper on the lens of the spot. The beamshaper is equipped with multiple magnets
which keep it firmly in position.
In order to remove the beamshaper, pull it off holding it by the edge.
Fig. 09