Article no.: 00035285
Showlite BM-60 Bubble Machine
ver092014
Introduction
Thank you for choosing this Bubble Machine. You now own a rugged and powerful state-of-the-art
machine. Prior to use, we suggest that you carefully read all of the instructions. By following the
instructions found in this user manual, you can look forward to exceptional performance from your
Bubble Machine for years to come. Please follow these operation, safety and maintenance
instructions to ensure along and safe life for your Bubble Machine.
Precautions
1) Read these instructions before operating the unit.
2) Please heed all safety warnings and keep these instructions for
future reference. Follow all instructions.
3) Do not use this device near water or moisture.
4) Clean only with dry cloth.
5) Do not install near any heat sources such as radiators, heat
registers, stoves, or other devices that produce heat.
6) Only use accessories specified by the manufacturer.
7) Do not open the device
8) For best results use only high quality bubble fluid
9) Refer all servicing to qualified service personnel. Servicing is
required when the device has been damaged in any way, such
as liquid has been spilled or objects have fallen into the device,
the machine was exposed to rain or moisture, does not operate
normally, or has been dropped.
Specifications:
Showlite BM-10:
Bubble Machine
Net voltage:
110-230V/AC – 50/60Hz
Power:
60W
Bubble output:
50 cbm
Fluid container:
0.6 liters
Dimensions:
240 (W) x 250 (L) x 220 (H) mm
Weight:
3 kg
Accessory:
Wireless remote control
Musikhaus Kirstein GmbH
Bernbeurener Strasse 11
86959 Schongau / Germany
Phone 0049-8861-909494-0 / Fax 0049-909494-19
Unpacking & Inspection:
Open the shipping carton and check that all equipment
necessary to operate the system has arrived intact. In addition
to the Bubble Machine, you should receive the following items:
1. This user manual.
2. A set of remote control like shown on picture above. Before
beginning initial setup of your Bubble Machine, make sure that
there is no evident damage caused by transportation. In the
event that the unit’s housing or cable is damaged, do not plug it
in and do not attempt to use it until after contacting your dealer
for assistance.
Setup:
Remove all packing materials from the bubble machine.
Place bubble machine on a flat surface. Do not place output close to persons.
Pour bubble liquid into the liquid tank, do not to exceed the maximum fluid level.
Connect remote control (receiver) with bubble machine. Connect power cord with net socket
Operation:
You can operate the BM-60 in two different modes. (1) “Direct mode”: turn switch on back panel to
“ON”. The wheel starts turning and the fan starts blowing. (2) “Remote control mode”: turn switch to
“WIRELESS”, you can Start/Stop the machine with wireless controller.
Your product is designed and manufactured with materials and components of high quality, which are recyclable
and can be reused. The symbol means that your product should be disposed of separately from household
waste when it reaches its end of life. Please dispose of this equipment at your local collection point or recycling
center. Please help to protect the environment in which we all live.
All specifications and appearances are subject to change without notice. All information was correct at time of
printing. Musikhaus Kirstein GmbH does not guarantee for the accuracy or completeness of any description,
photograph or statement contained in this manual. Printed colors and specifications may vary slightly from
product. Products from Musikhaus Kirstein GmbH are only sold through authorized dealer. Distributors and
dealers are not agents of Musikhaus Kirstein GmbH and have no authority to bind Musikhaus Kirstein GmbH
legally in any way. This manual is protected by copyright. Any copying or reprint, even in excerpts, is only
allowed with written consent of Musikhaus Kirstein GmbH. The same applies to reproduction or copying of
images, even in altered form.
