Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorestation.com
0003231
Page 10
REV A 1/25/05
SS1061E
SS10621E ELECTRIC WINCH INSTALLATION:
STEP 14:
Locate the electric winch, mounting plate, and
clamps in the hardware box (Detail N, page 13).
Note that the mounting plate has one hole on the
bottom and two on the top. Attach the electric winch
to the mounting plate by placing a 3/8” X 1” hex
bolt into the hole closest to the center of the brack-
et and then through the winch case. Secure
with a 3/8” hex flange lock nut. Place a 3/8” X 5”
hex bolt through a 3/8” flat washer and insert into
the top hole in the upright post. Place one of the
U-bolt yokes provided on the bolt so that it fits
the diameter of the upright post. Slip the winch
mounting bracket with winch attached onto
the bolt using the top hole of the mounting bracket.
Secure with a 3/8” hex flange lock nut. Attach the
bottom of the mounting bracket to the post with
another 3/8” X 5” bolt, flat washer, U-bolt yoke
and hex flange lock nut as described previously.
Tighten.
Attach the controller arm weldment to the front
crossmember with 3/8” X 3-7/16” X 3” square
U-bolt and 3/8” hex flange lock nuts. Note that
the controller arm can be positioned in or out
from the centerline of the hoist to best fit your
needs. Place the controller holder in the top of the
controller arm. Slip the controller into the holder
by feeding the cord into the slot in the holder
and then placing the controller into position.
Page 11
