Model 935
Moisture Tester
QUIcK-START GUIDE
NOTE: These steps are a general guide to quickly begin testing when first receiving
the tester. Some grains may require steps other than those presented, however the
touchscreen prompts will guide you through the moisture test regardless of the grain
being tested.
1. Unpack the tester and place the base of the tester on a flat, level and stable
surface.
2. Place the Grain Cell in the tester so that the green dots and connectors at the
base of the cell and the tester are aligned.
3. Connect the power cable between the tester and a suitable power source,
and move the power switch to the ‘ON’ position.
NOTE: The power receptacle and the power switch are located at the back of the tester
housing.
4. When prompted, place the Dump Cell
(clear plastic cylinder) in the top of the
Grain Cell so that the two cylinders form
a straight line.
NOTE: The Dump Cell should fit easily into the
Grain Cell.
5. Press the green start button (
) and
allow the self-test to begin.
6. When prompted, remove the Dump Cell.
7. Press the green continue button and
allow the self-test to continue.
8. Begin a moisture test with the displayed
chart or press MENU to select a
different chart, perform Foreign Material
or Damaged Kernel tests or modify the
tester settings:
• To begin a moisture test with the
displayed chart, proceed with Step 9.
