Shop-Vac SH14-C350, User Manual

Page: 6 / 36

12. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual
to ensure you have the proper filters installed for your
cleaning operation.
13. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
14. Insert machine hose end into inlet of tank. Twist
slightly to tighten the connection.
15. Attach the extension
wands to the accessory end
of the hose. Twist slightly
to tighten the connection.
FIGURE 11.
GENERAL SET UP
FIGURE 11
PAGE 5
FIGURE 4
FIGURE 5
FIGURE 7
2. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that bottom is
facing up. Remove any webbing that attaches the caster
feet to each other.
6. Make sure caster feet are fully
inserted into tank bottom and
secure with screws provided.
FIGURE 5
.
Assemble as follows:
9. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 8
.
10. Place “J” shaped tabs into the
slots on cord wraps
FIGURE 9 . Press down until
tabs snap into place.
11. Press down on center of tool
holder until tab latches on bottom
of lid. FIGURE 10.
TOOL HOLDER
ASSEMBLY
FIGURE 8
FIGURE 9
FIGURE 10
3. With tank inlet facing you,
take caster feet marked with
the letter
A, FIGURE 2
, and
place in the slots on left front
and right rear of tank also
marked with the letter
A
.
FIGURE 2
FIGURE 3
4. Make sure caster feet are fully
inserted into tank bottom and
secure with screws provided.
FIGURE 3
.
5. Take caster feet marked
with the letter B and place on
right front and left rear of tank
also marked with the letter B .
FIGURE 4 .
7. With tank inlet facing
you, attach hose holder A
to caster foot A, and hose
holder B to caster foot B.
FIGURE 6.
FIGURE 6
8. Apply pressure to front
of hose holder to snap into
place. FIGURE 7.
Return tank to upright
position.