Shop-Vac 87556-50, User Manual

Page: 6 / 36

PAGE 5
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
FIGURE 8
FIGURE 9
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
14. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 8.
15. Place filter retainer into
the top of the cartridge filter.
FIGURE 9.
13. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When picking
up fine dust or powders a high efficiency filter bag (not
standard with all models) must be used with the
cartridge filter.
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 10
FIGURE 11
18. Slide the cartridge filter
off the lid cage.
FIGURE 12.
16. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise
to tighten, locking the filter
into place. FIGURE 10.
17. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 11.
21. Check the filter for tears or small holes. If none are
found, reinstall the filter. To prevent damage to your
vacuum, do not use a filter with a hole or a tear.
19. To clean cartridge filter
shake or brush off excess
dirt. FIGURE 13.
20. Or rinse (from the inside
of the filter) with water.
FIGURE 14 . Dry
completely (approximately
24 hours).
CARTRIDGE FILTER
CLEANER
(not standard with all models)
ONLY USED FOR DRY PICKUP WITH CARTRIDGE
FILTER
To use the built in cartridge filter cleaner:
22. Rotate the cord wrap 180
degrees counter clockwise from
original position.
FIGURE 15.
FIGURE 15
ALWAYS DISCONNECT THE
PLUG FROM THE WALL
OUTLET BEFORE USING THE
CARTRIDGE FILTER CLEANER.
WARNING!