PAGE 5
ASSEMBLY
ATTACH/DETACH TOOLBOx
Attach:
1. Place toolbox on a flat, sturdy surface.
2. Place handle on toolbox in the upward position.
3. Pull bottom of the two toolbox latches in an outward motion then tilt top of
latches away from lid. Open lid allowing it to rest on the handle.
4. Position the back of the vacuum next to the side of the toolbox containing the
slot.
5. Slide tab on back of vacuum (located near top of tank) into slot on side of toolbox.
Push downward making sure slots on vacuum (located near the bottom of the
tank) attach to the tabs on the toolbox.
6. Close lid on toolbox.
7. Position top of latches on edge of lid and apply pressure with thumb to bottom
of each latch until it snaps tightly in place. Make sure lid is secured to bottom of
toolbox and latches are clamped securely.
8. Make sure vacuum is secured to toolbox.
Detach:
9. Place toolbox on a flat, sturdy surface.
10. Place handle on toolbox in the upward position.
11. Pull bottom of the two toolbox latches in an outward motion then tilt top of
latches away from lid. Open lid allowing it to rest on the handle.
12. Grasp handle on top of vacuum and lift upwards until vacuum is disconnected
from the toolbox.
