The. indexable. inserts. are. very. sharp.
and.can.easily.cut.your.hands..ALWAYS.
use.caution.when.handling.these.parts.
to.reduce.risk.of.personal.injury.
Straightedge
Outfeed Table
Figure.29.
Straightedge just touching
cutterhead body.
Black Lines Represent
Straightedge Positions
from Overhead View
Figure.30.
Straightedge positions for
verifying outfeed table parallelism.
-33-
Model W1876 (For Machines Mfd. Since 7/20)
SE
RV
IC
E
If the infeed and outfeed tables are not parallel with the
cutterhead and each other, then poor cutting results and
kickback can occur.
Item(s).Needed.
Qty
Precision Straightedge 36" .....................................1
T-Handle Torx Driver T-25 .....................................1
Hex Wrench 4mm ...............................................1
Flat Head Screwdriver
3
⁄
8
" ....................................1
Checking.Outfeed.Table
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove cutterhead guard and fence.
3.
Place straightedge on outfeed table so it hangs over
cutterhead, then insert included Torx driver into
cutterhead rotation guide and rotate cutterhead
until straightedge just touches cutterhead body (see
Figure.29
).
4.
Place straightedge in positions shown in
Figure.
30
. In each position, straightedge should touch
cutterhead and sit flat on outfeed table.
— If straightedge touches cutterhead body and sits
flat across outfeed table in all positions, then
outfeed table is already parallel with cutterhead.
Follow the
Checking.Infeed.Table
instructions on
Page.34
.
— If straightedge
does not
touch cutterhead body
and sit flat across outfeed table in any of the
positions, then outfeed table is not parallel with
cutterhead. Perform
Adjusting.Table.Parallelism
procedure on
Page
35
.
Checking/Adjusting.Table.
Parallelism
Summary of Contents for W1876
Page 52: ......
