-5-
D2260A Mini Mobile Base Instructions
8.
Secure each corner bracket to two rails with (4)
M8-1.25 x 16 hex bolts, and 8mm lock nuts, as shown
in
Figure 11
.
Tip:
Thread the hex bolts into the rails but do
not tighten the lock nuts against the rails until
instructed later.
Figure 11.
Rails secured to fixed corner
brackets.
x 4
Each side rail-to-corner bracket connection must have
a minimum of two hex bolts installed, making a total
of four bolts at each corner, as shown in Figure 11.
Do not load a machine onto the base until all of these
bolts have been installed and tightened. Loading a
machine onto the base before completing assembly
can result in the machine falling or tipping over,
resulting in serious personal injury.
9.
Thread a knob into the top of a foot post several
turns, then insert a foot into the bottom of the foot
post, as shown in
Figure
12
. The knob shaft should
pick up the foot when it comes in close proximity
since the top of the foot is magnetized.
10.
Repeat
Step 9
to install the remaining knob and foot
into the other foot post.
11.
With the mobile base sitting on the floor, adjust the
knobs to raise the feet off the floor.
12.
Proceed to
Mounting Machine onto Mobile Base
, on
Page 11
.
Knob
Figure 12.
Installing foot pad and knob
into a foot post.
Foot Post
Foot
