Back to seat angle:
The back seat angle can recline from 0-40 degrees. Any change to
the back to seat angle (recline) may influence the ability of the user
to reach the brakes for propelling, so they may need to have position
changed (on seat plate under buck - see opposite picture). The buck
will need to be removed from the base to do this.
Seat length:
The seat length can be adjusted by 100mm. The covers will need to
be removed and the buck taken off the base frame to do this. This is
done by adjusting two nuts underneath the seat and extending the
seat to the appropriate length and securing again once adjusted.
(size 10 spanner)
seat length adjustments
bottom of buck
The purpose of the adjustable tilt is to encourage good postures and
to stop the user from slumping in the Madiba2Go Active when tired. It
is a useful position for rest. Be sure to set tilt for the best position for
user to push him/herself. It is usually not necessary to change the tilt
often. If it is changed, the brakes may need to be adjusted to be able to
be used when user is pushing the Madiba2Go Active. (Refer to brake
adjustment points shown on base frame picture a few pages back.)
How do I use the tilt in space?
