Antenna Installation
6
f. Using the four clamps, clamp the mount saddle to the feedline.
g. Place the top radome half over the radiator and into the mount, slipping the
end of the mount under the closure plate.
h. Place the bottom radome half over the radiator and feedline and into the top
radome half, inserting its mount into its closure plate.
i. Bolt the radome halves loosely to the mount with the mount bolts
(3/8" with lock washers and flat washers).
Figure 4. Radome installation
j. Fasten the two radome halves together with the 1/4" flange hardware,
starting at the feedline side and working around both sides to the outer edge.
Tighten the flange hardware.
NOTE
You may have to squeeze the radome flanges together slightly with a
clamp to start the nuts. Get all these nuts and bolts in place, then
tighten them.
