8. Position upstairs floor on top of front panel
and railings. Secure through railings into
upstairs floor framework using 8 x 80 mm
screws, 2 per railing.
9. From inside of building, secure through
front panel framework into upstairs floor using
4 x 80 mm screws.
1. Position upstairs side panel on top of
upstairs floor and next to main side panel.
Make sure the cut-out in the panel is next to
the main side panel. Secure panels together
using 2 x 60 mm screws.
2. Secure upstairs side panel to floor using 2
x 60 mm screws.
3. Repeat for other side.
1. Place back gable on top of back panel.
Secure through back panel framework into
gable framework using 8 x 60 mm screws.
2. Join side panel to gable through framework
using 2 x 60 mm screws per side.
3. Place large partition panel onto upstairs
floor. Secure to floor through panel framework
using 4 x 60 mm screws. Secure to side
panel using 2 x 60 mm screws.
4. Position
small partition
panel. Secure
to floor through
panel frame-
work using 2 x
60 mm screws.
Secure to side
panel using 2 x
60 mm screws.
5. Place up-
stairs partition
railing into
aperture of
large partition
panel. Secure
through panel
framework into
railing using 2 x
60 mm screws,
one at the top
and one at the
bottom. Repeat
for other side of railing.
6. Place front gable onto upstairs floor.
Secure through panel framework into floor
using 8 x 60 mm screws. Secure to small side
panels using 2 x 60 mm screws per side.
1. Slide large back roof panel into position
using the cut out at the ridge of the back
gable and the cut out in the side panel as a
guide.
The front of the panel will rest on part of the
partition panel framework. Note: The roof
panel has a gap at one end of the bearers,
this goes at the back of the building. Repeat
for other large back roof panel.
2. Slide front roof panels into position using
the cut out at the ridge of the front gable and
the cut out in the side panels as a guide. The
back of the panels rest on the partition frame-
work.
3. Secure front and back roof panels together
through framework, from the inside, using 2 x
60 mm screws per side.
4. Secure roof panels together at the ridge,
from the inside, using 4 x 60 mm screws.
5. Secure roof panels to gable ends through
gable framework into roof bearers using 2 x
60 mm screws per roof panel.
6. Secure to ridge of partition using 1 x 60
mm screws per roof panel.
7. Secure along the length of building through
roof panel into framework of walls using 5 x
40 mm nails per side.
E Upstairs Side Panel
F Gable Assembly
G Roof Assembly
