- 6 -
Fig.2 Direction of Harness connection
4-2
Body
AccStick has a LED, main power switch and connector to connect to the PC.
a)
Main power switch
Turn on the power when you start measuring. Do not attempt to prematurely
terminate the measurements during the measuring process by turning the power
off. An error will occur and no data will be available for download from the
unit.
After measuring, connect to the PC without turn off the power to prevent any
issues. Turn off the power after data has been downloaded to your PC
successfully. Also, retain the power turn off condition after measuring to prevent
any issues with over discharge.
b)
Connector for connection with PC
AccStick has a connector to connect to the PC to configure the measuring
conditions or to charge the battery via the specified harness and micro USB
cable.
c)
LED
AccStick has a blue LED on its body that will flash when capturing data.
Also flashing will be appeared during standby when the time trigger mode.
4-3
Module for data connection / charging of battery
A special module for data connection and charging of battery is needed to connect with the PC.
