9
REMOTE CONTROL
Before making any connections observe the following:
• Ensure the mains voltage supply matches the label on the supplied plug- Pack (+/- 10%).
•
Ensure that the power switch is OFF.
•
Ensure that all system grounds (earth) are connected to a common point.
•
Avoid powering equipment within a system from multiple power sources that may be separated by large distances.
•
Connect all audio video sources and destination equipment.
•
Power up all source and destination audio-visual sources.
•
For each destination output select the appropriate input source by using the front panel input 1-8 select buttons. The supplied IR
remote control. Or through the RS-232 serial communications port.
•
Upon power up the switcher will return to its last used setting before Powered down.
REMOTE CONTROL
1. & 2. SWITCH POWER ON or OFF:
Controller with a power ON and OFF
3. DESTINATION : 1 THRU 4 OUTPUT SELECTION:
Press the destination button to select the output display channel.
4. SOURCE : 1 THRU 4 INPUT SOURCE SELECTION:
Press input 1~4 sources with selection button
5. FUNCTION KEY:
ALL - function selection button
DEMO or ENTER - function selection button
EDID - function selection button
LOCK - function selection button
6. SELECT EDID MODES : PRESS SOURCE BUTTON 1 THRU 2
1. Mode 1 : FSS (Fast Speed Start)
2. Mode 2 : H24-3D
3. Mode 3 : H24M-3D
4. Mode 4 : H36
5. Mode 5 : H36M
6. Mode 6 : H36-3D
7. Mode 7 : H36M-3D
8. Mode 8 : AUTO