Shindaiwa T2822X, Owner'S/Operator'S Manual

Page: 8 / 32

8
Cutting Attachment Shield
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
WARNING!
NEVER operate the unit
without the cutting attachment shield
installed and tightly secured!
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-head
cap screws.
NOTE:
It may be necessary to loosen the retain-
ing nut and clamp screw to adjust cutting
attachment shield mounting plate.
2. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
CAUTION!
Make sure the subshield is completely
hooked at the hook receiver.
4. Attach the subshield to the cutting
attachment shield by snapping the
hooks into the hook receivers..
Outer Tube
Socket-Head
Cap Screws
Clamp Screw
Retaining
Nut
Drain
Screw
Mounting Plate
Shim
Shim
Bracket
Cutting Attachment
Shield w/subshield
4-6 mm
Throttle Free
Play
Adjust Throttle Lever Free Play
The throttle lever free play should be approximately 4-6 mm. Make sure that
the throttle lever operates smoothly without binding. If it becomes necessary to
adjust the lever free play, follow the procedures and illustrations that follow.
Throttle Lever Free Play
1. Loosen the air cleaner cover knob and remove the air cleaner cover.
2. Loosen the lock nut (A) on the
cable adjuster.
3. Turn the cable adjuster (B) in or
out as required to obtain proper
free play.
4. Tighten the lock nut (A).
5. Reinstall the air cleaner cover.
A
B