Shindaiwa EB212, Owner'S/Operator'S Manual

Page: 14 / 28

14
IMPORTANT
Maintenance, replacement or repair of emission control devices and systems may be performed by any repair
establishment or individual, however, warranty repairs must be performed by a dealer or service center authorized
by shindaiwa corporation the use of parts that are not equivalent in performance and durabil-ity to authorized parts
may impair the effectiveness of the emission control sys-tem and may have a bearing on the outcome of a warranty
claim.
skIll level
Level 1 = Easy to do. Common tools may be required.
Level 2 = Moderate difficulty. Some specialized tools may be required.
maIntenance Intervals
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit. Allow unit to cool before performing service. Wear
gloves to protect hands from sharp edges and hot surfaces.
m
aIntenance
component / system
maIntenance
procedure
reQ'd
skIll
leVel
daIly or
before use
eVery
refuel
3 months
or 90
hours
yearly
600 hours
Air Filter Inspect/Clean 1 I / C * R *
Choke Shutter Inspect/Clean 1
I / C
Fuel Filter Inspect/Replace 1
I * I / R *
Fuel Cap Gasket Inspect/Replace 1
I *
Fuel System Inspect/Replace 1 I (1) * I (1) *
Spark Plug Inspect/Clean/Replace 1
I / C / R *
Cooling System Inspect/Clean 2
I / C
Muffler Spark Arrestor Inspect/Clean/Replace 2
I / C / R *
Cylinder Exhaust Port Inspect/Clean/Decarbon 2 I / C
Recoil Starter Rope Inspect/Clean 1
I / C *
Screws/Nuts/Bolts Inspect/Tighten/Replace 1
I *
maIntenance procedure letter codes: I = Inspect, r = replace, c = clean
Important note
- Time intervals shown are maximum. Actual use and your experience will determine the
frequency of required maintenance.
maIntenance procedure notes:
(1) Low evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.
* All recommendations to replace are based on the finding of damage or wear during inspection.