10
Assembly of the Handle
T2510
Barrier
Square Nut
Handle
Bolt
Barrier
About 250mm
1. Put the 4 square nuts in the frame
of barrier. See Figure 7.
2. Fit the handle and barrier over the
outer pipe and tighten the 4 bolts.
3. Position the handle about 250mm
ahead of the throttle housing end.
4. Secure the handle by alternately
tightening the 4 bolts in a diagonal
or “crisscross” fashion.
C2510
Handle Bracket
Lower Cap
Band
Cable
Outer Tube
Figure 7A
Figure 7
Bolt
Throttle Grip
Handle
Label
1. Loosen the 2 bolts of the lower cap
and remove the lower cap.
2. Position the handle bracket on
the handle label stuck to the outer
tube.
3. Attach the lower cap with the 2
bolts and tighten the bolts. Make
sure the handle stays as the
illustration shows.
4. Secure the cable to the outer tube
with the 2 bands as the illustration
shows. The 2 bands are in the tool
bag.
