Shindaiwa C242S, Owner'S/Operator'S Manual

Page: 7 / 24

Handle T242
1. Put the 4 square nuts into the frame of
the barrier. See figure 6.
2. Fit the handle and barrier over the outer
pipe and tighten the 4 bolts.
3. Position the handle about 250 mm ahead
of the throttle housing end.
4. Secure the handle by alternately tight-
ening the four bolts in a diagonal or
“crisscross” fashion.
Figure 6
Barrier
Square Nut
Handle
Bolt
Barrier
About 250 mm
Handle
Assembly and Adjustments
Handle Bar C242
1. Use the 4 mm hex wrench to remove
the lower cap retaining screws from the
handlebar bracket. Remove the cap from
the bracket. See Figure 7.
2. Position the handle on the outer tube
forward of Handle Positioning Label
as shown in Figure 7. Reassemble the
lower cap to the handlebar bracket in
the reverse order of disassembly.
3. Locate the handle in the best position for
operator comfort.
4. Firmly tighten both lower cap retaining
screws.
5. Install the protector sleeve on the outer
tube. See Figure 7.
C242
Outer Tube
Mounting Bracket
Socket-Head
Cap Screw
Handlebar
Protector Sleeve
Figure 7
Ignition Switch
Throttle
Trigger
Hanger
Shoulder Strap
Handle Positioning Label
Attach handle on this line
7