Shimpo FGV Series, Instruction Manual

Page: 23 / 32

-22-
5.7.3 Standard Mode Memory
5.7.3.1 Accessing Memory Data
1. Turn the POWER off. Press MEM and hold, then press and release POWER. Release MEM when you see "STd" on the display. The unit will
alternate between showing the data block number, and the recorded measurement value of that block.
2. Press MEM to review the previous data block recorded.
3. Press UNIT to cycle through the available recorded statistics. In Standard mode, the available statistics are as follows: positive maximum value,
negative maximum value, positive minimum value, negative minimum value. This is covered in greater detail in the next section, 5.7.3.2.
4. Press PEAK to output the recorded memory via RS-232C. Refer to section 6.2 regarding RS232C communication.
Key operation Display
Turn power off
PEAK PEAK
ZERO
MEM
UNIT
1. Hold down MEM
2. Press POWER
PEAK PEAK
ZERO
MEM
UNIT
3. Release POWER
ZERO Deletes the current data block, but only if you have the last block selected.
UNIT
Cycles through the available statistics.
PEAK
Transfers the recorded memory data via RS232C, and exits memory mode.
Powers down the FGV-XY.
MEM
Release MEM when
"CNT" is displayed.
Last memory block Previous memory block
First memory block
MEM
MEM
1.
2.
MEMORY
MEMORY
MEMORY
MEMORY
POWER
POWER
MEMORY
MEMORY
MEMORY
MEMORY
MEMORY
MEMORY
POWER
POWER
PEAKPEAK
UNITUNIT
ZEROZERO