1.
2.
7.
Pull
Tighten
2
Replace the bell crank cover and tighten the cover fixing screw.
2)
The edges of the link
should be between the
yellow lines.
Within
4 mm
Tightening torque:
4 – 6 Nm {40 – 60 kgfcm}
Inner cable
fixing nut
Yellow line
Yellow line
Edge of link
Set the Revo-shift lever to .
Next, pull the inner cable so that the edges of the link on the
main bell crank unit are between the two yellow lines on the
window, and then tighten the inner cable fixing nut at that
position.
After tightening the inner
cable fixing nut, cut off any
excess inner cable.
Set to
2
SET
SET
Push rod
The end of the push rod should project from
the end of the hub axle by approximately 14
mm.
Approx. 14 mm
Tightening torque:
3 – 5 Nm {30 – 50 kgfcm}
Installation of bell crank
5 mm Allen key
or 10 mm
spanner
Main unit
installation bolt
While pushing the main bell crank unit onto the hub axle, align the
serrations inside the main bell crank unit with the flange nut, and
then push the main bell crank unit on until it touches the end of
the hub axle. In this position, tighten the main unit installation bolt
onto the hub axle.
SET
SET
Edge of
window
End of hub axle
Flange nut
The edge of the window and
the end of the hub axle
should be aligned.
Insert the push rod into the hub axle.
