5.
6.
3.
4.
Link
Inner cable fixing plate
Inner cable fixing nut
Loosen
JAPAN
JAPAN
Cover fixing screw
Bell crank cover
3
Set the inner cable onto the pulley.
Insert the inner cable into groove (A) from the inside of the
projection on the pulley, and then pass it through the hole in the
outer casing holder.
1)
Hook the inner cable into groove (B) in the pulley, and pull the
inner cable so that the inner cable drum fits into the hole (B) in
the pulley. After this, insert the outer casing into the outer
casing holder.
2)
Replace the indicator cover and tighten the cover fixing screw.
Loosen the cover fixing screw, and then remove the bell crank
cover.
Set the inner cable into the link of the main bell crank unit.
Bell crank side
Loosen the inner cable fixing nut on the main bell crank unit.
Next, pass the inner cable from the cable adjusting bolt along
the groove in the link and then in between the link and the
inner cable fixing plate.
1)
Be sure to pass the inner cable
through the groove in the link.
Cable adjusting bolt
OK
Not OK
Note:
Check that the inner cable is correctly routed
along the inside of the projection on the pulley.
Groove (A) in pulley
Projection
on pulley
OK
Not OK
Hole in outer casing
holder
Hole (B) in pulley
Groove (B) in pulley
Outer casing holder
1
2
