83
14. Communication with Peripheral Devices
14.2.3 Command Codes
Caution
Inputting characters and command codes not shown here into the balance
may not only alter the previous settings but may also impair proper mea-
surement.
If by mistake characters or commands not shown here are entered into the
balance, immediately unplug the power supply cable and wait about ten
seconds before plugging it in again.
Command Code
Function
Description
D01
Continuous output
The balance continuously outputs every 110ms .
D05
1 time output
Corresponds to
[PRINT]
key
D06
Auto Print
See
D07
1 time output with stability
information
The status of the stability mark is appended to the head of
the data with output. S: when the stability mark is showing
U: when the mark is not showing
D08
1 time output at stability
After command input, the data is output at the first appear-
ance of the stability mark.
D09
Halt output
Auto Print and continuous output halted
Q
ON/OFF switching
Switches between standby status and measurement sta-
tus.
T
Taring
Corresponds to the
[O/T]
key
TS
Taring after stability wait
After command input, taring is done at the first appear-
ance of the stability mark.
C18
Span calibration
M
Formulation mode
measurement
+
Add-on mode measurement
R
Total reset
All application measurements terminated and reset
mg
mg unit registry
∗
PERCENT
% unit registry
PCS
Piece counting registry
CT
ct unit registry
MOM
Monme unit registry
∗
SDENCE
Solid specific gravity registry
LDENCE
Liquid specific gravity
registry
%
100% setting
