83
1
3
5
2
4
6
7
8
12
14
13
9
10
11
66
Settings
Settings
Table 1. Functions which can be assigned to the touchless sensors
Key Name
Function
Door open and close keys (Left) *2
Door open and close keys (Right) *2
Opening and closing glass doors configured using the position memory function.
(Refer to
^
[ Measuring using the automatic door function (position memory
function).] (P.35) for details on the position memory function.)
[PRINT]
Outputting weighing values to external devices (printers, PCs, etc.)
[0/T]
Executing taring (zeroing out)
[ION]
Ionizer ON/OFF
* The door open and close key (left) can only be assigned to the left touchless sensor, while the door
open and close key (right) can only be assigned to the right touchless sensor.
!
Caution
Touchless sensor settings will not be reset even if the power is turned OFF and ON
again. (Position memory function settings will be reset however.)
Switching touchless sensor operation methods
The W-AD Series features a multifunction mode which allows for a maximum of 4 functions to be
assigned to the touchless sensors. The touchless sensor operation methods will vary depending on
whether this mode is on or off.
* Multifunction mode is ON by default.
< Touchless sensor operation when multifunction mode is enabled >
When multifunction mode is enabled, a maximum of 4 functions can be assigned to operation using
the touchless sensors. When multifunction mode is enabled, functions can be assigned to each of the
operations shown in A through D of Figure 1 below.
For example, you can set it so that swiping your hand or fingers above the left touchless sensor will
operate the doors, and so that hovering your hand over the left touchless sensor (for approximately 2
seconds) after placing a sample and the weight value has stabilized will output the data. This allows for
carrying out a series of operations including door opening and closing, taring, and weight value output
without using the balance main body keys.
B: Right touchless sensor (long)
Hover hand over sensor to light up
the LED for approximately 2 seconds.
D: Left touchless sensor (long)
Hover hand over sensor to light up
the LED for approximately 2 seconds.
A: Right touchless sensor (short)
Swipe hand over sensor and
remove (after LED lights up)
LED
Close-up
view
C: Left touchless sensor (short)
Swipe hand over sensor and
remove (after LED lights up)
Figure 1. Touchless sensor operation when multifunction mode is enabled
* For A and C, you swipe hand or fingers over the touchless sensor, the LED turns ON, then you remove your hand or fingers and
the LED turns OFF and the function activates.
