Connect the Posi-Tap connector to the rear wheel speed sensor Red/Yellow stripe wire for nonABS
models and for ABS equipped models connect the Posi-Tap connector to the Green wire . The connector
is located under the riders seat to the right side of the sub-frame..
Posi-Tap connector installation guide:
1. Do not strip run wire.
2. Unscrew the big end cap counter-clockwise
3. Insert the run wire in the big end cap slot.
4. Screw the big end cap to pierce and provide signal.
2.
The Full Race Unit will require negative (ground) connection to power up, connect the single black
wire to the battery NEGATIVE
(-)
lead!
3.
Remove your original shift rod and install SP-Shift Sensor with the fitting rod(s) provided to its
place. Route the wire to the Full Race Unit control box and plug it in. When installing the sensor, make
sure all counter nuts are locked and the sensor wire is not under tension when pressing the gear lever all
the way up and down. The rod and sensor internal threads are made DUAL THREADS (left and right hand
at the same time) which makes fitting universal.
Summary of Contents for C-K11
Page 5: ......
