Shibaura CM314, Operator'S Manual

Page: 49 / 74

HYDRAULIC OIL FILTER (SUCTION & HST)
The hydraulic system is equipped with spin-on
type oil filters.
NOTE: Replace the filters after the first 50
hours of operation and every 300 hours
thereafter following the procedure below:
1. Remove the drain plug
A
of the front gear
case and discharge the HST oil.
2. Unscrew the oil filter
B
,
C
and discard.
3. Coat the gasket on the new filter with a film of
oil. Screw the filter into place until the gasket
contacts the sealing surface, then tighten the
filter approximately 3/4 of a turn by hand. Do
not over tighten.
4. Install the oil filter in place and supply new
HST oil from the oil inlet
D
.
5. Start the engine and check the hydraulic oil
filter for leaks.
6. Stop the engine and check the hydraulic oil
level. Replenish if necessary.
3-14
LUBRICATION AND MAINTENANCE
D
TRANSMISSION, FRONT AXLE AND HYDRAULIC OIL
A
TRANSMISSION, FRONT AXLE AND HYDRAULIC
SYSTEM OIL DRAIN
C
B
HYDRAULIC OIL FILTER
2. Hydraulic Oil Filter
3. HST Oil Filter
B
HYDRAULIC OIL FILTER
C
HST OIL FILTER