Shibaura CM314, Operator'S Manual

Page: 36 / 74

3-1
SECTION 3
LUBRICATION AND MAINTENANCE
This section gives full details of the service procedures necessary to maintain your CM Mower at peak
efficiency while the lubrication and maintenance charts provide ready reference to these requirements.
NOTE: Ensure that the unit is on level ground and that all hydraulic rams are extended, where
applicabel before checking oil levels.
To prevent contamination when changing oils or filters etc., always clean the area around the
filler, level and drain plugs, dipsticks and filters. Ensure that oil contained within remote cylinders
is clean, has not broken down due to long storage and is of the correct grade.
After the first 50 hours of operation of your CM mower the following maintenance is required:
50-HOUR SERVICE
INOPERATIVE SERVICE CHECKS
1. Tire pressure
2. Check air cleaner hose connection
3. Replace diesel fuel filter(s)
4. Tighten injector line fittings
5. Radiator coolant level
6. Fan belt tension
7. Battery cleanliness and vent openings,
electrolyte level and charge
8. All electrical cables, terminals and
wires
9. Drain and refill engine oil
10. Replace engine oil filter
11. Transmission and front axle oil level
12. Rear axle oil level
13. Replace HST oil filter
14. Replace hydraulic system oil filter
15. ROPS and seat belt
PERFORMANCE SERVICE CHECKS
1. Engine operation including throttle and
governor operation
2. HST transmission
3. Steering control
4. Differential lock engagement and
disengagement
5. Brake action
6. All optional equipment and accessories
OPERATIVE SERVICE CHECKS
1. Lights and Instruments for proper
operation, and fuel shut down with key
switch off
2. Fluid and oil leaks
3. Maximum no-load speed and idle
speed adjustments
4. Starting and starter switches
5. Hydraulic system:
･
Lift control lever operation
6. Operation of safety devices:
･
PTO disengagement system
･
Engine stop system
PROPERLY MAINTAINED EQUPMENT
IS SAFE EQUIPMENT