Sherwood SBD-15, Owner'S Manual

Page: 16 / 22

16
Assembling the Sanding Dish
Cover and the Sanding Dish
Table
(Fig. 6-7)
1.
Make sure the motor is switched off.
2.
Mount the sanding dish cover with the four
encolsed screws and the four flat washers.
3.
Mount the sanding dish table on the sanding
dish guard.
4.
On both sides of the sanding dish guard
there are two angular notches. Push both
hooks that are on the inner side of the table
into these notches. These two hooks are the
centre of rotation for the table.
5.
First push the table horizontally against the
sanding dish and then vertically upwards.
For tightening the sanding dish use both
yellow knob screws . Tighten the knob
screws into the dish guard through both
guide slots that are situated on the table.
6.
Position the sanding table to the required
angle to the dish and tighten the two knob
screws.
One accessory is a scale . Whenever you intend
to make double mitre sectcion, use the scale.
Adjust the required angle and place the rod of
the scale into the groove of the sanding disc.
Rod
Scale
Sanding Dish
Guard
Sanding Dish
Table
Fig. 6
Fig. 7
Sanding Dish
Table
Table Locking
Knob
Set Up & Operation