Sherwood RX-4109, Operating Instructions Manual

Page: 13 / 112

13
ENGLISH
Adjusting the tone (bass and treble)
8.
Enter the tone mode.
• Each time this button is pressed, the
corresponding tone mode is selected and shown
for 3 seconds as follows:
▄
Note
• When the tone direct function is activated, the
tone mode cannot be entered and “TON DIR”
flickers for 2 seconds.
9.
At the desired tone mode, adjust the tone as desired.
• If the tone display disappears, start from the step
8 again.
▄
Note
• Extreme settings at high volume may damage
your speakers.
• In general, the bass and treble levels are
adjusted to 0.
10.
To listen to a program source without the tone effect.
• “TON DIR” is displayed, “DIRECT” lights up and
the sound that bypasses the tone circuitry will be
heard.
• To cancel the tone direct function, press this
button again to display “TON CTRL”, and then
"DIRECT" goes off.
Adjusting the sound volume balance
11.
Enter the balance mode.
• “BAL” and the balance level is displayed for 3
seconds.
12.
Adjust the sound volume balance between the left and right speakers.
• If the balance display disappears, start from the
step 11 again.
▄
Note
• In general, the balance level is adjusted to 0.