Sherwin-Williams ULTIMATE 824-030, Owner'S Manual

Page: 5 / 32

7387A
7148A
K
Fig. 1
J
E
F
D
A
G
R
0137
M
N
H
S
L
T
P
Major Components
C
B
U
A Motor (Under shield shown) DC motor, 120 Vac, 60 Hz, 18A, 1 phase
B Pressure Adjusting Knob Controls fluid outlet pressure
C ON/OFF Switch Power switch that controls 120 Vac power to sprayer
D Drive Assembly Transfers power from DC motor to the displacement pump
E Fluid Filter Filter of fluid between source and spray gun
F Secondary Fluid Outlet Second spray gun operation is connected here
G Pail Hanger Container for fluid to be sprayed may be hung here
H Displacement Pump Pressures fluid to be sprayed through spray gun
J 50 ft. (15 m) Main Hose 1/4 in. ID, grounded, nylon hose with spring guards on both ends
K RAC IV Tip Guard Reverse-A-Clean (RAC) tip guard reduces the risk of fluid injection injury
L Contractor Gun High pressure spray gun with gun safety latch
M RAC IV SwitchTip RAC SwitchTip atomizes fluid and removes clogs from spray tip without
removing tip from spray gun
N 3 ft. (0.9 m) Hose 3/16 in. ID, grounded, nylon hose used between 50 ft. hose and spray gun
to allow more flexibility when spraying
P Pressure Drain Valve Relieves fluid pressure when open
R Pressure Control Controls motor speed to maintain fluid pressure. Works with pressure ad-
justing knob.
S Spray Gun Safety Latch Inhibits accidental triggering of spray gun
T Primary Fluid Outlet Hose and spray gun is connected here
U 15/20 Amp Switch Allows sprayer to operate on 15A service with reduced performance